Предыдущая тема :: Следующая тема |
Автор |
Сообщение |
ivsem
Зарегистрирован: 01.02.2006 Сообщения: 63 Откуда: Киев
|
Добавлено: Чт Ноя 12, 2009 12:03 pm Заголовок сообщения: Как востановить файл *.dgn созданный в MS 7? |
|
|
При загрузке файла в MS 7 появляется сообщение "Unable to open file..."
При загрузке файла в MS 8 на экране появляется только часть изображения.
Пересохраненный из MS 8 в MS 7 файл в MS 7 не открывается.
Пробую востановить файл при помощи программы EDG.EXE
Пока результат нулевой.
Может кто подскажет? |
|
Вернуться к началу |
|
|
ivsem
Зарегистрирован: 01.02.2006 Сообщения: 63 Откуда: Киев
|
Добавлено: Чт Ноя 12, 2009 2:48 pm Заголовок сообщения: |
|
|
Нашел в интернете алгоритм востановления файла программой EDG.exe
Follow these steps in order:
1. Create a good file using the same settings as the file that has gone bad. The preferred method is to copy the original seed file to a new file named GOOD.DGN.
2. It is recommended that you copy both the bad and good files into the EdG directory (the default is \win32app\ustation\EdG or \Bentley\program\EdG). This will save the trouble of entering path statements.
3. Backup the bad design file. There is no undo function in EdG.
4. Change to the EdG directory.
5. At the command prompt, enter the following commands:
edg good.dgn (Enter the EdG environment with the good file)
open new.dgn (Create a new output within EdG)
edg bad.dgn (Open the damaged file; substitute the name of your corrupted file)
patch wtf (Enter the patch facility of EdG)
0 (Zero sets the Words-to-Follow value to zero)
a 5 (Instruct EdG to search and not stop until 5 valid elements are found)
save (Exit the patch facility and save the patched element)
type next (Move one element further into the design)
write rest (Write all elements into NEW.DGN)
close (Close NEW.DGN)
exit (Exit EdG)
The file NEW.DGN will be your new, good file.
Получил я по этому алгоритму "исправленный" файл
Но в MS 7 он не грузится |
|
Вернуться к началу |
|
|
ВалВл
Зарегистрирован: 08.02.2006 Сообщения: 138
|
Добавлено: Чт Ноя 12, 2009 3:05 pm Заголовок сообщения: |
|
|
Попробуйте, открыв файл в MS-8, сохранить его в DWG, а потом в MS-7 импортировать из DWG. Иногда помогает. |
|
Вернуться к началу |
|
|
|